Outdoor Network Gigabit Ethernet Switch Huawei S3700-52P-EI-48S-AC
Product Description
The S3700 series enterprise switches (S3700s) are next-generation energy-saving Layer 3 switches. The S3700 utilizes cutting-edge hardware and Huawei Versatile Routing Platform (VRP) software to provide high-performance access and aggregation to an enterprise campus network. The S3700 is easy to install and maintain. With its flexible VLAN deployment, PoE capabilities, comprehensive routing functions, and capability to migrate to an IPv6 network, the S3700 helps enterprise customers build next-generation IT networks. In addition, the S3700 uses advanced reliability technologies such as stacking, VRRP, and RRPP, enhancing network reliability and diversity.
The S3700 is a box device that is 1 U high. It is available in a standard version (SI), an enhanced version (EI), and an advanced version (HI). The SI version provides Layer 2 functions and basic Layer 3 functions. The EI version supports complex routing protocols and provides more functions than the SI version offers. In addition to the functions of EI, HI supports higher-specification MAC addresses, routes, and multicast table entries, along with powerful hardware capabilities.
List of software features supported
Attribute | Description |
|---|
Ethernet features | Ethernet | - Operating modes, including full duplex, half duplex, and auto-negotiation
- Operating rates of an Ethernet interface, including 10 Mbit/s, 100 Mbit/s, 1000 Mbit/s, and auto-negotiation
- Flow control on interfaces
- Jumbo frames
- Link aggregation
- Load balancing among the links of a trunk
- Interface isolation and forwarding restriction on interfaces
- Suppression of broadcast storms
|
VLAN | - Access modes of access, trunk, hybrid, and QinQ
- Default VLAN
- VLAN mapping
- Selective QinQ
- Voice VLAN
|
MAC | - Automatic learning and aging of MAC addresses
- Static, dynamic, and blackhole MAC address entries
- Packet filtering based on source MAC addresses
- Limitation on MAC address learning on interfaces
|
ARP | - Static and dynamic ARP entries
- ARP on a VLAN
- Aging of ARP entries
|
Smartlink | - SmartLink
- SmartLink multi-instance
- MonitorLink
|
LLDP | LLDP |
Ethernet loop protection | MSTP | - STP
- RSTP
- MSTP
- BPDU protection, Root protection, loop protection
- Partitioned STP and BPDU tunnels
|
RRPP | - RRPP protective switchover
- Single RRPP ring, tangent RRPP rings, and intersecting RRPP rings
- Hybrid networking of RRPP rings and other ring networks
|
IPv4/IPv6 forwarding | IPv4 features | - ARP/RARP
- ARP proxy
- Auto-detection
|
Unicast routing | - Static routes
- RIP-1/RIP-2
- OSPF
- BGP
- IS-IS
- Routing policies and policy-based routes
- uRPF check
- VRF
- DHCP Client/Server/Relay
- DHCP snooping
|
Multicast routing | - IGMPv1/v2/v3
- PIM-SM
- Multicast routing policy
- RPF
|
IPv6 features | - IPv6 protocol stack
- IPv6 unicast routing protocols: RIPng and OSPFv3
- VRRP6
- SNMP IPv6
- IPv4/IPv6 transition technologies
|
Others | VRRP |
Layer 2 multicast | Layer 2 multicast | - IGMP Snooping
- Prompt leave
- Multicast traffic control
- Inter-VLAN multicast replication
- Controllable multicast
|
Ethernet OAM | EFM OAM | - Neighbor discovery
- Link monitoring
- Fault notification
- Remote loopback
|
CFM OAM | - CCM check
- MAC Ping
- MAC Trace
- Hardware-based CCM check (only supported by S3700-26C-HI)
|
Y.1731 | |
QoS | Traffic classification | - Traffic classification based on the combination of the L2 protocol header, IP quintuple, outgoing interface, and 802.1p field
- Traffic classification based on the C-VID and C-PRI of QinQ packets
|
Traffic behaviors | - Access control after traffic classification
- Traffic policing based on traffic classification
- Re-marking based on traffic classification
- Class-based packet queuing
- Combination of traffic classification and traffic behaviors
|
Queue scheduling | |
Congestion avoidance | - S3700SI and S3700EI: SRED
- S3700HI: WRED
|
Rate limit on outbound interfaces | Rate limit on outbound interfaces |
Configuration and maintenance | Terminal service | - Configurations through command lines
- Help information in English and Chinese
- Login through console and Telnet terminals
- Information exchange between terminals through the send function
|
File system | - File system
- Directory and file management
- File upload and download through FTP or TFTP
|
Debugging and maintenance | - Centralized management of logs, alarms, and debugging information
- Electronic label
- User operation logs
- Detailed debugging information for diagnosing network faults
- Network test tools such as traceroute and ping commands
- Interface mirroring and flow mirroring
|
